Hi all, making a new bit of loom from the drivers side plug in engine bay but have lost the original drawing i made up. can anyone tell me wire locations. the lower 4 are head light and indicator, but as far as i can remember the coil has 3 connectors to it.? any ideas. cant seam to find an appropiate diagram.
starter wireing.
- Thread starter TD
- Start date
Hi TD,
If your wiring's anything like mine..I had all 6 from the block going to RH lights (2 each for indicators,side,head).
Chopped and changed my ignition wiring so many times that it's miles away from standard but it would of been 1 LT to solenoid 1 to dizzy and 1 HT to dizzy. When you start adding shift lights and rev limiters it confuse's things a little, also depends what ignition system you run.
If your wiring's anything like mine..I had all 6 from the block going to RH lights (2 each for indicators,side,head).
Chopped and changed my ignition wiring so many times that it's miles away from standard but it would of been 1 LT to solenoid 1 to dizzy and 1 HT to dizzy. When you start adding shift lights and rev limiters it confuse's things a little, also depends what ignition system you run.
I have a '66 LC and the following applies; white to ignition coil - blue/white to headlamp (main beam) via connector block mounted on front slam panel - blue/red to headlamp (low beam) via connector block - green/red to nearside direction indicator (connects to green in connector block) - white/brown to oil pressure switch - white/red to starter solinoid via bullet connector - brown to starter solinoid via bullet connector
