Pre-airflow front kick panels

[Steve 155C]

Should the left hand side front kick panel have a cut out to fit around the regulator mounting bracket?

 

[Pete G]

Yes Steve

I got replacements from Aldridge and had to get the Stanley knife out (used the original as a template)

 

[Steve 155C]

Thanks Pete. My set are from Aldridge , hence the same problem. I'll have to rummage in the loft to see if I have the original to use as a template.

 

[Pete G]

If you get the rear seat/boot divider you will have a similar problem as the aeroflow cars don't have the rear parcel shelf support bar (Stanley knife again!)

 

[Steve 155C]

Yep - also found that out

 

[Simon G]

I'm a bit confused by the last posts regarding the boot divider. I need one of these from Aldridge and my car doesn't have the support bar as it's an aeroflow car. What difference does this make and will the one from Aldridge not fit properly?

 

[Steve 155C]

Hi Simon , the one from Aldridge will fit your car , but if you had the support bar which is fitted verically between the boot floor and the parcel shelf then you need to cut a notch in the divider board so it fits behind the support bar, as Pete and I had to. Not a big deal. I'll get a pic for the next QB so you can see what I mean.

 

[Pete G]

 

[Simon G]

Thanks Steve and Pete for your advice

 

[cortina-mk1]

there is also images here of the different types on offer to suit both models

both kick panels and boot separator board

HERE

 

[Steve 155C]

Looks like you are one step ahead of Aldridge Jewels. I wish I new you were remaking the bulkhead padding - it took me ages to find a decent pair.

 

[cortina-mk1]

oh well steve